Accumulate, Metropolix style?

[mgd]

In the wake of the very interesting conversation with mvdirty I have created a MWE to show Accumulate by means of tables. See the attached project created with V1.24 RC11.

This project shows a couple of peculiarities. Let me start by explaining what I'm trying to achieve followed by my observations.

• I have a 4 note sequence (C-6, C-6, C-6, B-5).
  
• There are 3 tables, all set SOURCE PTN-SFX, TYPE >LOOP, LENGTH 1
  
• Table 00 does nothing
  
• Table 01 is 8 steps long and applies increasing (by semitones) transposition up (from 0 to 5th up)
  
• Table 02 is 7 steps long and applies increasing (by full tones) transposition down (from 0 to octave down)
  

What I expect is that initially the above 4 note sequence plays as is and on each following round notes 2 and 3 will be changed by tables 01 and 02 respectively. Since the tables are 7 and 8 steps long I would expect to have 56 (7*8) different versions of the 4 note sequence and the 57th round being the same as the first round.

What happens is quite different:

• The initial (unchanged) sequence is played twice before the tables start to change the notes. To me this looks like an initialization issue of the table clock.
  
• The HP 00 in lines 09 and 08 respectively seem to be ignored. Both tables 01 and 02 loop over the full 16 steps. Is that intentional?
  

I also observed that the setting of SOURCE and TYPE of the 3 tables is not independent of each other. In particular when I set Table 00 to e.g. INT.Tick then all tables run at INT.Tick (or so it seems). Similar with TYPE. When I set Table 00 to Type >RESYNCH I only hear the unchanged sequence regardless how often I loop it (tried at least 50 or so rounds; no change). Is that intentional?

Kind regards,
Michael