Accumulate, Metropolix style?

[XORadmin]

In the wake of the very interesting conversation with mvdirty I have created a MWE to show Accumulate by means of tables. See the attached project created with V1.24 RC11.

This project shows a couple of peculiarities. Let me start by explaining what I'm trying to achieve followed by my observations.

• I have a 4 note sequence (C-6, C-6, C-6, B-5).
  
• There are 3 tables, all set SOURCE PTN-SFX, TYPE >LOOP, LENGTH 1
  
• Table 00 does nothing
  
• Table 01 is 8 steps long and applies increasing (by semitones) transposition up (from 0 to 5th up)
  
• Table 02 is 7 steps long and applies increasing (by full tones) transposition down (from 0 to octave down)
  

What I expect is that initially the above 4 note sequence plays as is and on each following round notes 2 and 3 will be changed by tables 01 and 02 respectively. Since the tables are 7 and 8 steps long I would expect to have 56 (7*8) different versions of the 4 note sequence and the 57th round being the same as the first round.

What happens is quite different:

• The initial (unchanged) sequence is played twice before the tables start to change the notes. To me this looks like an initialization issue of the table clock.
  
• The HP 00 in lines 09 and 08 respectively seem to be ignored. Both tables 01 and 02 loop over the full 16 steps. Is that intentional?
  

I also observed that the setting of SOURCE and TYPE of the 3 tables is not independent of each other. In particular when I set Table 00 to e.g. INT.Tick then all tables run at INT.Tick (or so it seems). Similar with TYPE. When I set Table 00 to Type >RESYNCH I only hear the unchanged sequence regardless how often I loop it (tried at least 50 or so rounds; no change). Is that intentional?

Kind regards,
Michael

The setup of your table doesn't match your expectations.
In your sequence you always switch between the tables every 4 steps and end up on step 12 to table 00. So the first 4 steps table 00 is playing, next 4 steps table 01, next 4 steps table 02 and the last 4 steps table 00, which you increase then by 1 table step. With the table step increments always table 00 is playing and so the Hops from the other tables are never executed.
In my opinion the tables are running correctly here.