05-01-2021, 08:56 PM
Thank you mvdirty, I'll check out that thread.
Meanwhile I've started playing with it and I'm stumbling over a couple of other things here. I've attached my project to this post but here is a short description as to what I'm trying to do:
Now I move the Cursor into row 02 and hit SHIFT START (row 00 is for tuning my VCOs and play A-7 which in my setup should be 440 Hz). This is what happens:
As a side note:
In the Live/Record Setup I can only select Transpose T1 but not T2...T8. Similar for pass to CV1 (no CV2...CV4) and Quantize to CV1 (no CV2...CV4). This is independent of the track I'm on. Is that intended and how would I get hold of the other values?
If all of the above problems are dealt with in the thread mvdirty mentioned in his post I apologize for the noise - I have not yet looked at it. I'll do it after I've sent this post (or probably tomorrow since it is getting late...).
Kind regards,
Michael
Meanwhile I've started playing with it and I'm stumbling over a couple of other things here. I've attached my project to this post but here is a short description as to what I'm trying to do:
- Tracks 7 & 8 are allocated to my NSA1 (CV16) and play a couple of patterns
- Tracks 1-6 are set to Modular and on Track 6 I have the Transposition Table as well as some Probability Functions to jump between the 3 pattern islands (starting on rows 02, 05 and 08 respectively). Track 6 plays a C-5 (0V; set to -5/+5) and CV6 is patched into Input 4
- Pattern 0E on Track 6 has a transposition table that randomly choses a note from the c Minor Scale +/- 1 Octave (+/- 0C==12 semitones). Type is set to >ONCE (tried >RESYNC and >LOOP w/o any change)
- In the Live/Record Setup I've configured Input 4 Live to TRANSPOSE ALL.
- In Track Setup for the various Tracks I set 1-6 to TRANSPOSE AVOID and 7&8 to ALLOW
Now I move the Cursor into row 02 and hit SHIFT START (row 00 is for tuning my VCOs and play A-7 which in my setup should be 440 Hz). This is what happens:
- The screen shows that Track 6 is playing C-5. I do measure 0V. When I switch from -5/+5 to 0/+10 I measure +5V.
- In the Nerd Menu all my tracks including 1-6 have TRK Transpose set to -3c/-3b/-39 (or similar) and I can't change that via SHIFT + CURSOR UP/DOWN/LEFT/RIGHT (nothing happens; may be intended)
- consequently all notes are way too low. When I switch Transpose to AVOID in the Track Setup of Tracks 7&8 all pitches are as expected but of course I can't transpose.
- My Pattern switching logic works as intended
As a side note:
In the Live/Record Setup I can only select Transpose T1 but not T2...T8. Similar for pass to CV1 (no CV2...CV4) and Quantize to CV1 (no CV2...CV4). This is independent of the track I'm on. Is that intended and how would I get hold of the other values?
If all of the above problems are dealt with in the thread mvdirty mentioned in his post I apologize for the noise - I have not yet looked at it. I'll do it after I've sent this post (or probably tomorrow since it is getting late...).
Kind regards,
Michael