06-02-2021, 06:00 PM
(This post was last modified: 06-02-2021, 06:02 PM by MATTHS.
Edit Reason: clarification
)
Hi all, I am having a bit of trouble with launching a whole row of patterns.
It appears that the Nerdseq waits until the end of the previous pattern before it launches a new one. This means that if I have a pattern on 2 different tracks with different pattern lengths, then any new patterns will not launch together when launching a new row via SHIFT+PLAY.
Have I explained that clearly?
Ideally I would like the Nerdseq to launch a whole new row of patterns so that they all start at the same time - ignoring the lengths of the previous patterns. For example, I go to a new row, hit SHIFT+PLAY and the Nerdseq will wait until the end of the bar and then play all of the new patterns in the new row together. Is there an option to do this?
I should add that I have experimented with the SHIFT+PLAYx2 but this does not always trigger the new patterns at the next cue point but instead waits until the pattern ends.
Thank you!
It appears that the Nerdseq waits until the end of the previous pattern before it launches a new one. This means that if I have a pattern on 2 different tracks with different pattern lengths, then any new patterns will not launch together when launching a new row via SHIFT+PLAY.
Have I explained that clearly?
Ideally I would like the Nerdseq to launch a whole new row of patterns so that they all start at the same time - ignoring the lengths of the previous patterns. For example, I go to a new row, hit SHIFT+PLAY and the Nerdseq will wait until the end of the bar and then play all of the new patterns in the new row together. Is there an option to do this?
I should add that I have experimented with the SHIFT+PLAYx2 but this does not always trigger the new patterns at the next cue point but instead waits until the pattern ends.
Thank you!