06-02-2021, 08:48 PM
(06-02-2021, 08:40 PM)mgd Wrote: I'm not sure that SHIFT+STARTx2 exists as a command, at least it does not seem to be documented. Feature request?
Pressing START 2 times, will trigger the next pattern faster, after an amount of steps, set up by the Project setting ‘Live Quantize’, derived from the main 64 step clock. (Page 18)
So I am presuming that, if you hold down SHIFT and press START twice (x2) then this applies to the row of patterns and thus launching all patterns on a row synchonised.
Perhaps holding down SHIFT and pressing START twice (x2) does not exist as a key command? Can the Admin confirm this?