07-10-2021, 05:11 PM
(This post was last modified: 07-10-2021, 05:12 PM by enzosangiorgio.)
Hello! Got my video expander a couple days ago and finally got a chance to install it.
I updated my firmware and it sees the expander, but whenever i try to change settings and save (mainly to switch to normal ntsc) it just said 'Fail'
Turns out the SD card cracked when I put in the first ribbon cable (super tight there) and then fried when i turned it on.
New SD card still comes up 'Fail'
Was there anything on that card that NEEDS to be there? Can I download it somewhere to put it on a new card?
I updated my firmware and it sees the expander, but whenever i try to change settings and save (mainly to switch to normal ntsc) it just said 'Fail'
Turns out the SD card cracked when I put in the first ribbon cable (super tight there) and then fried when i turned it on.
New SD card still comes up 'Fail'
Was there anything on that card that NEEDS to be there? Can I download it somewhere to put it on a new card?