07-27-2021, 12:49 AM
I didn't want to start a new thread, but I'm trying to prep some samples for the nerdseq.
Specifically I am loading the SP1200 drum pack from samples from mars.
These started out as 24-bit floating point samples, and I have used sox to convert them to 16-bit PCM. When I use sox --i command, it shows that they are 16-bit signed integer encoded at 44.1kHz rate. The test file (a kick drum) I am using from the set is only 23.8KB, but it won't load. I always get the 'Load Sample Error', even on a completely blank project. Is there some other preperatory step that I need to do to make them suitable for nerdseq?
Thanks.
Geremy
Specifically I am loading the SP1200 drum pack from samples from mars.
These started out as 24-bit floating point samples, and I have used sox to convert them to 16-bit PCM. When I use sox --i command, it shows that they are 16-bit signed integer encoded at 44.1kHz rate. The test file (a kick drum) I am using from the set is only 23.8KB, but it won't load. I always get the 'Load Sample Error', even on a completely blank project. Is there some other preperatory step that I need to do to make them suitable for nerdseq?
Thanks.
Geremy

