09-20-2021, 09:48 PM
(09-19-2021, 06:36 PM)mgd Wrote: <disclaimer>
I obviously can only talk about what the prototype did and what Thomas hinted as to what the final version probably will do.
</disclaimer>
That having said:
The whole thing consists of two (presumably identical) units and I'm describing one of them.
It is a 4 voice synth/oscillator with a couple of cool waveforms among them a supersaw. There are two pods which are freely assignable. E.g. Tuning and Spread of the waves (in the supersaw; I think this also goes for other waveforms but don't take my word for it). There is a Sum Out of those up to 4 voices and a Gate/Trigger. On the screen this is supposed to be 5 columns (similar to the CV16; 4 for notes and one for gate/trigger). All that times two
Sound wise I really liked it. There is clearly a use case for pads, but you could also use it for (multivoice) melody lines etc. In my current setup I would remove one of my CV16 and also save on a few oscillators.
I'm not sure but I think Thomas had shown it at least briefly in one of his previous videos. Not sure he played it then. The prototype has/had 4 redish pods arranged in diagonal pairs in the upper and lower half of the module. Under the pods are the two plugs each. It is either 6 or 8 HP wide.
While the HW seems finished the SW is not.
Kind regards,
Michael
Thanks for the info!