11-19-2021, 11:56 PM
Hi !
So I was recalibrating my Nerdseq and kinda freaked out because two of my mod outputs were unresponsive, with values slowly going up/down and not matching the voltage they were supposed to send. After spending two hours trying to figure out why (a.k.a emptying my whole case to check if there was a power issue) the solution was actually pretty dumb: I had a super long Glide modulation on two tracks. And they were still active when I was in the calibration menu. That's all.
So in case it happens to any of you: the calibration menu seems to be sensitive to current values on tracks. Just go through all tracks and double check "Glide Modulate" is 000.
I don't know if it's a feature or a bug so I don't open an actual issue, but maybe it would be an interesting feature to allow the user to disable any custom modulation/output configuration in the calibration menu
(or a warning in the manual maybe? Page 82 on current version)
That's all, thanks
So I was recalibrating my Nerdseq and kinda freaked out because two of my mod outputs were unresponsive, with values slowly going up/down and not matching the voltage they were supposed to send. After spending two hours trying to figure out why (a.k.a emptying my whole case to check if there was a power issue) the solution was actually pretty dumb: I had a super long Glide modulation on two tracks. And they were still active when I was in the calibration menu. That's all.
So in case it happens to any of you: the calibration menu seems to be sensitive to current values on tracks. Just go through all tracks and double check "Glide Modulate" is 000.
I don't know if it's a feature or a bug so I don't open an actual issue, but maybe it would be an interesting feature to allow the user to disable any custom modulation/output configuration in the calibration menu
(or a warning in the manual maybe? Page 82 on current version)That's all, thanks