Hey! Loving the nerdseq but have encountered an issue when trying to set a track to midi and enter the pattern to start editing it. On a side note, have also have encountered a (seemingly random) crash (Error 1c 9d055dec) that I don't have solid repro steps for but will post if that changes!
Reverting to v1.24 prevents this from happening.
My setup: NerdSeq, with more triggers 16, more cv 16, and io-expander.
Steps:
1) Launch NerdSeq to blank project.
2) Project > Track Assign > Assign any track to MIDI and Set. *
3) Go to the track in Sequencer, assign a new pattern with SHIFT+OK.
4) Press OK to go into the pattern (pressing PATTERN button also reproduces this).
5) Crash - Most of the time will reboot (without an error message), once it hung on a red screen until I manually turned the power supply off.
Notes:
* Roughly happens about 80%-90% of the time when following the above.
* Sometimes I could set track 1 to midi and this would be fine, other times I'd set it to track 1 and it would crash - Seems to happen consistently if assigning MIDI to track 6.
Reverting to v1.24 prevents this from happening.
My setup: NerdSeq, with more triggers 16, more cv 16, and io-expander.
Steps:
1) Launch NerdSeq to blank project.
2) Project > Track Assign > Assign any track to MIDI and Set. *
3) Go to the track in Sequencer, assign a new pattern with SHIFT+OK.
4) Press OK to go into the pattern (pressing PATTERN button also reproduces this).
5) Crash - Most of the time will reboot (without an error message), once it hung on a red screen until I manually turned the power supply off.
Notes:
* Roughly happens about 80%-90% of the time when following the above.
* Sometimes I could set track 1 to midi and this would be fine, other times I'd set it to track 1 and it would crash - Seems to happen consistently if assigning MIDI to track 6.