NerdSEQ plus Bitbox Micro (slicer mode)

[mgd]

Thanks for your help.


In the end the only thing that worked with Bitbox Micro in trigger mode has been repeated triggers from NerdSEQ. I used "11" triggers (see attached picture). Track setup without trigger delay. Pattern with CV and trigger at the same time.

I'm a bit confused. I don't know why this is the only thing that worked. And I don't know if the slice was triggered repeatedly (ON/OFF/ON/OFF) because it was so fast.

Could someone explain me what happens?

The Bitbox has way to many settings to know that.
To understand guess what might have happened there are a few things yet unknown. Here comes a short and probably incomplete list of questions:
- What are the envelopes set to? (e.g. short Attack/Decay and low Sustain?)
- What happens when you set the trigger to 02 (longer delay, then gate) followed by a gate off?
- Have you tried trigger lengths of e.g. 20 or 40?
- What ranges of trigger delay in the N3rd Menu have you tested?
- What type of sound is it that you try to play? (fast/slow attack, etc.)
- If possible try to look at things with a scope. I find that invaluable.
- What happens when you trigger the Bitbox from another trigger source?
- How do other sound sources react, when you send them the same triggers from the NerdSEQ?

I'm sure there are more...

Kind regards,
Michael