08-20-2022, 08:55 AM
(08-20-2022, 07:54 AM)Joscuzz Wrote:(08-19-2022, 09:30 PM)XORadmin Wrote: Wrote:(08-19-2022, 08:49 PM)Joscuzz Wrote: I only have a 4pin connector cable bridging the Breakout module to the ES9, and no other resources to experiment with ins/outs. I'll take a look at it again to see if I can my head around your suggestion.
Thank you so much.
I think he meant the regular TRS connectors. They are (mostly) 2 types. TRS-A and TRS-B. If both are not the same then it doesn't work.
NerdSEQ 2HP Midi expander uses the Midi Standard TRS-A. You need to match the ES9 I-O for that and all will be fine.
Just assuming you talk about the 2HP expander and not the regular using DIN connectors.
It is the MIDI I/O expander DIN connectors to the Expert Sleepers Breakout MIDI Input that I'm trying to hook up. Will this not work?
Edit: Does the MIDI I/O expander run at 5V or 3.3V? I ask because the ES9 runs at 3.3V and I believe this could be the problem to the compatibility of NerdSeq MIDI I/O with the ES9.
Just to be sure we are talking about the din connector to din connector?
NerdSEQ midi is using 5 Volt as it suppose to be but even if 3,3V is used things should work always as it is a current source, not a voltage thing.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!

