12-27-2022, 04:32 PM
(12-27-2022, 02:35 PM)XORadmin Wrote:(12-27-2022, 10:57 AM)eliclement Wrote: @Thomas1: C-A it is.
When programming my value validator function I was going through all the commands and have the following questions:
- The manual on p.28 says "...the note scaling begins from C-0 to A#9." should it be: "...the note scaling begins from C-0 to C-A." (I checked it and indeed the NerdSeq highest note input value the different columns is always C-A.
- Is it correct that the FX command "CBPB" has values for the Swing from -64 to 62 (FX value range (FX column value range 0x600 up to 0x67E)?
- Is it correct that the FX command "CBPB" has values for the "Trk jump to row" from 0x00 to 0xFC (0-252) (FX column value range for 0x700 up to 0x7FC)? I should expect it to go up to 255
- Is it correct that the FX command "CBPB" has values for the "All jump to row" from 0x00 to 0xFC (0-252) (FX column value range for 0x800 up to 0x8FC)? I should expect it to go up to 255
- What does the following FX command "TABL" with value: "STP" mean? Does this mean the current table stop command?
Thanks for the great work on the new release 1.27!
Cheers!
5: Table 'Stop' (same as ** in the table column)
Following is updated in V1.27A:
2: -63 to +63 from now
3,4: Set to FE now (they are 254 rows)
@Thomas,
Ok thanks!
Do you check the version of the pattern files upon importing? Do you allow only pattern files to be imported with the same NerdSeq firmware version?
I tried to import a single pattern file (not the bulk one) and got "Pattern import failed". It can be my bad constructed pattern file during testing here, but I just want to make sure if you do allow or restrict only certain versions for imports...

