02-17-2023, 05:47 PM
Ah, I I was messing around with my new fresh project and almost the same thing happen, so I'll attach the project, which is almost a fully reset project.
There are two identical Automators in slot 0 and in slot 1. Starting the Automator in Slot 0 doesn't do anything (including LFO, etc), but the one in slot 1 works just fine.
This was working a few minutes before without changing any other settings than Automator destination, as far as I recall.
There are two identical Automators in slot 0 and in slot 1. Starting the Automator in Slot 0 doesn't do anything (including LFO, etc), but the one in slot 1 works just fine.
This was working a few minutes before without changing any other settings than Automator destination, as far as I recall.