02-17-2023, 07:25 PM
(02-17-2023, 05:47 PM)visti Wrote: Ah, I I was messing around with my new fresh project and almost the same thing happen, so I'll attach the project, which is almost a fully reset project.
There are two identical Automators in slot 0 and in slot 1. Starting the Automator in Slot 0 doesn't do anything (including LFO, etc), but the one in slot 1 works just fine.
This was working a few minutes before without changing any other settings than Automator destination, as far as I recall.
Without looking I think you check the latest bug reports. Should be that then.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!