I2C Expander

[XORadmin]

Will this also be possible:
- Use an envelope with its output on MOD 1
- Then on track 1, use the MOD column to control some parameter of this envelope (say release time), but without messing up the actual MOD 1 output? I.e. the MOD value specified in track 1 only updates the envelope release parameter, but does not actually contribute to the MOD 1 output, which should only be set by the envelope.

Sure that works. But keep in mind that the changing release got direct impact on the MOD output as well.
I actually just did that and it looks quite funny on the envelope curve :-)

Ah wait..didn't read that too well yet. The MOD column will automatically output on the MOD, so that isn't possible anyways.
I did MOD output (which is the output of the envelope) does change the release time of the same envelope.

I think it would be interesting if it were possible to prevent the MOD output from the mod column, especially for cases where the MOD output is used for envelopes. Because, currently, this makes the MOD column unusable.

I don’t plan to change anything in the main sequence mechanism. 
You can set variables from the FX columns which you can use within the mappings.