06-22-2023, 12:11 PM
I have a simple 16 step sequence with eight notes running up a scale (C D E F G A B C). Each row has a trigger setting of 40 and I have auto-gating turned off. I am triggering a Qu-Bit Surface and there are no other parameters on the sequencer rows.
When I add PROW in the fourth FX column for each row that has a note/trigger and put in percentages that are lower than 100, my expectation was that the that entire row would either fire or not (i.e. I would get a CV change and trigger or neither). The actual behavior is that I will sometimes get a CV change without a trigger or a trigger without a CV change. When I remove the triggers and turn on the auto-gating, I still get CV changes without a trigger (but not a trigger without a CV change). Firmware is 1.27C.
Is this the expected behavior of PROW?
When I add PROW in the fourth FX column for each row that has a note/trigger and put in percentages that are lower than 100, my expectation was that the that entire row would either fire or not (i.e. I would get a CV change and trigger or neither). The actual behavior is that I will sometimes get a CV change without a trigger or a trigger without a CV change. When I remove the triggers and turn on the auto-gating, I still get CV changes without a trigger (but not a trigger without a CV change). Firmware is 1.27C.
Is this the expected behavior of PROW?