06-22-2023, 12:39 PM
(06-22-2023, 12:11 PM)sllopes Wrote: I have a simple 16 step sequence with eight notes running up a scale (C D E F G A B C). Each row has a trigger setting of 40 and I have auto-gating turned off. I am triggering a Qu-Bit Surface and there are no other parameters on the sequencer rows.
When I add PROW in the fourth FX column for each row that has a note/trigger and put in percentages that are lower than 100, my expectation was that the that entire row would either fire or not (i.e. I would get a CV change and trigger or neither). The actual behavior is that I will sometimes get a CV change without a trigger or a trigger without a CV change. When I remove the triggers and turn on the auto-gating, I still get CV changes without a trigger (but not a trigger without a CV change). Firmware is 1.27C.
Is this the expected behavior of PROW?
No, PROW does indeed fire the whole row or not. I am pretty sure that you got another probability still activated here (check in the current values screen of the track). Also you set the probability on one step and set it to another value on another step. It stays on it's value until you change it again.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!

