09-03-2023, 02:08 PM
(09-02-2023, 07:03 AM)kriskeyman Wrote: To follow up on this, how do I start it again? I’m trying to create an FX, that when run stops the Nerdseq sequencer for a certain number of ms, or waits for a certain number of clock pulses received before automatically starting again.
With the upcoming firmware you could generate that in the mappings. Just add a command for the delay and when that is done start the sequencer.
Something else is not (automatically) possible. I could think about adding a automator, using one output + squarewave, connect to one input. In the input mapping you choose the start function. Now you fire the 'slow' automator and when the square goes from low to high, it should start the sequencer again, be sure to stop the automator after that (from the started sequence). Offset and Phase settings might be needed. Also it starts where the cursor is + this is a theoretical idea and I am not sure if that would definitely work.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!