from 2.0 firmware trigger 16 and more cv never founds

[persi74]

hi guy's i have io expander the old one and always never show in nsa scan but is styill work,but i dont found in the track assign the option for trigger 16 and more cv...where is the destination?
thanks a lot

[XORadmin]

hi guy's i have io expander the old one and always never show in nsa scan but is styill work,but i dont found in the track assign the option for trigger 16 and more cv...where is the destination?
thanks a lot

I don't think there is any crash situation here, it work all fine with everyone else so there is either an issue with the installation or you got a hardware problem. 
Do they have different addresses, are they installed properly? Do they work when only one expander is connected? Maybe you remove and plug in the cables once. Did you ever hot-plug the expanders? Which firmware is running on the CV16?

The IO Expander is never being detected on NSA scan. It just works.

Not firmware related I assume, so I will move it into the general questions topic.

[persi74]

hi guy's i have io expander the old one and always never show in nsa scan but is styill work,but i dont found in the track assign the option for trigger 16 and more cv...where is the destination?
thanks a lot

I don't think there is any crash situation here, it work all fine with everyone else so there is either an issue with the installation or you got a hardware problem. 
Do they have different addresses, are they installed properly? Do they work when only one expander is connected? Maybe you remove and plug in the cables once. Did you ever hot-plug the expanders? Which firmware is running on the CV16?

The IO Expander is never being detected on NSA scan. It just works.

Not firmware related I assume, so I will move it into the general questions topic.

everething worke fine ,i put a mixer euro no skiff friendly near the nerd and one flat cable was off
sorry