Fire CV16 triggers from mapping matrix

[rubberband]

Is it possible to add a mapping command to fire a simple trigger pulse on a CV16 channel via the mapping matrix?  Similar to how you can fire the envelopes using EV1O with the destination being NSA 1-4 and output 1-16

But instead just use the new built in TT8 command for a 40ms trigger pulse, to the output of my choice.

This would mean that a) I don't have to use all my CV16 envelopes up - I'm assuming that if you triggered the same envelope more than once you'd reset whichever instance fired first and only get the full 40ms from whichever fired last. and b) I wouldn't have to initialize a track for the CV16 necessarily because I wouldn't have to configure the expander's envelopes.

Does that make sense?  Is it even possible with the hardware?  I realize it's a bit of an edge case feature..

[XORadmin]

You can use the trigger function with the CV16 which is a one-shot LFO.
Set the LFO to type 7 which makes it a trigger LFO. And from the mapping you can fire the LFO using CV16 LF1X .... (for LFO1).

In the mappings you can also define the LFO setting to set it to type 7. This can also be set always on project load (Use the XLOD source in the mapings). There is no need to create a CV16 track for that.

Also You got 8 envelope and 8 LFO settings per CV16. But you can use each envelope and LFO independend on any of the outputs. So you need only for example one Envelope setting and fire it on different times on different outputs and they never affect each other. It is just a preset setting that you can then assign to an output.