[NO BUG] Table at Dualchord 2 not work

[andisyntz]

at Dualchord, the table only works on Dualchord 1, not yet on Dualchord 2.
Thank you for your efforts.

[XORadmin]

at Dualchord, the table only works on Dualchord 1, not yet on Dualchord 2.
Thank you for your efforts.

I just checked it again and it does work.
FYI, the first 4 columns are used for Dualchord waves 1-4 and columns 5+6 are for the waves 5+6.

[andisyntz]

at Dualchord, the table only works on Dualchord 1, not yet on Dualchord 2.
Thank you for your efforts.

I just checked it again and it does work.
FYI, the first 4 columns are used for Dualchord waves 1-4 and columns 5+6 are for the waves 5+6.

I use Dualchord waves 1-4 for the left side and 5-8 for the right side. When I set FX1 TABL 00 04, this only affects Dualchord waves 1 to 4. The table has no effect on waves 5-8. I have tried placing the table on different FX columns (1-3), but this also has no effect on Dualchord 5-8.
My column setup:
Note 1 Destination Out 1 Wave 1
Note 2 Destination Out 1 Wave 2
Note 3 Destination Out 1 Wave 3
Note 4 Destination Out 1 Wave 4
TRIG1 Destination Track Trigger
Note 5 Destination Out 2 Wave 5
Note 6 Destination Out 2 Wave 6
Note 7 Destination Out 2 Wave 7
Note 8 Destination Out 2 Wave 8
TRIG 2 Destination DC-TR Output 2
It is possible that the bug only occurs on output 2.

[XORadmin]

Check the column setup in the tables. There is a dedicated column setup for which the tables should be executed or not.
Waves 5-8 are always output on the 2nd output.

[andisyntz]

Check the column setup in the tables. There is a dedicated column setup for which the tables should be executed or not.
Waves 5-8 are always output on the 2nd output.

Ahh, thank you, Ahh, I didn't see that.