Patches with assimil8or

[xgodzillao]

Hi,

I use the assimil8or for drums with trigg16
I use a table to select the 8 zones to play on the assimil8or.
but if on a line I have a table to select a zone and a trig, the table only occurs for the next trig.
I know there's some priorities but only for FX right ?
I would expect the table to switch the zone from assimil8or right on the trig. But maybe that's an assimil8or problem having the trigger instantly and the CV coming from the table slightly delayed it's not taken into consideration ?
I found the Loc.Trig Delay that I set to 16ms but result is the same.

thx for any idea.

[XORadmin]

The table runs in parallel to the regular patterns but if it is getting started then it will do it's first action right after the pattern processing.
This is only different for transpose related table execution where the first position will be fetched already when deciding on which note to play from the pattern.

Settings in a table will indeed be executed after the pattern and that is the reason your zone will be active on the next trig.

Local trigger delay is for the local trigger output but not for the Trigger16 outputs.

This is a bit tricky to achieve. The Local CV/Gate outputs are combined and so specific delays etc can be handled there. But The T16 is 'independend' from any CV changes.
Isn't there a setting in the Assimilator to force a delayed CV readout?

[xgodzillao]

OMG you'r right ! There's a Gate delay option in Utilites / Preferences
2ms seems the minimum to get it right.

[XORadmin]

OMG you'r right ! There's a Gate delay option in Utilites / Preferences
2ms seems the minimum to get it right.

Ah ok good. Good product :-)