03-16-2019, 11:07 PM
I have a bunch of different sequencers including a NerdSeq clocked by Pamela. I always try to wire up a master reset button so that (when, not if) sequencers get out of sync I can pull everything back to hit on the “1”.
At times the NerdSeq doesn’t seem to reset all that cleanly. Steps will be a bit ahead or behind the other sequencers. I can’t figure out what’s going on. Maybe it’s looking at the wrong edge of the reset pulse? Is there any way to configure things about the reset input, like rising vs falling edge activation or threshold level? I am clocking Nerdy at 24ppqn, maybe something to do with that?
Luckily I don’t have to use the master reset all that often but it would be nice for it to be solid when I do need it...
At times the NerdSeq doesn’t seem to reset all that cleanly. Steps will be a bit ahead or behind the other sequencers. I can’t figure out what’s going on. Maybe it’s looking at the wrong edge of the reset pulse? Is there any way to configure things about the reset input, like rising vs falling edge activation or threshold level? I am clocking Nerdy at 24ppqn, maybe something to do with that?
Luckily I don’t have to use the master reset all that often but it would be nice for it to be solid when I do need it...

