XOR Userforum › Products › NerdSEQ › NerdSEQ Expanders v
CV16 - calibration

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
CV16 - calibration
Kubase Offline
Member
***
Posts: 75
Threads: 21
Joined: Oct 2020
Reputation: 4
#11
11-21-2020, 10:22 AM
I've updated the firmware. Had to 'Get Calibration' initially but so far all is good. Thanks!
Find
Reply
XORadmin Offline
Administrator
*******
Posts: 4.125
Threads: 138
Joined: Jul 2017
Reputation: 247
#12
11-21-2020, 10:29 AM
Not sure why you keep using get calibration. You never got to touch it normally and it does nothing.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!  Smile
Find
Reply
Kubase Offline
Member
***
Posts: 75
Threads: 21
Joined: Oct 2020
Reputation: 4
#13
11-21-2020, 12:57 PM
Well after the firmware update I had to, Braids was virtually subsonic until I did.
Find
Reply
Kubase Offline
Member
***
Posts: 75
Threads: 21
Joined: Oct 2020
Reputation: 4
#14
11-29-2020, 07:54 PM
To confirm - all OK now.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)