10-21-2024, 02:39 PM
(10-19-2024, 10:54 PM)XORadmin Wrote: The NerdSEQ doesn't send the reset pulse frequently but only if you stop the sequencer so all connected gear will 'resynchronize'.
You could try to send a reset pulse at the end or begin of your pattern using the SPFX command.
Hi!
yes I tried the SPFX command as well as shift+start but the CR doesn't seem to receive the reset. My malekko voltage block and metropolix receive the reset from the Nerdeseq correctly. I wonder if this is a specific issue with the CR?
Thanks

