Note/Trigger/Modulation Indicator improvements?

[XORadmin]

Hi, I tried searching but only found one thread of this topic (I might be searching incorrectly though!)

Are there any plans to look at improvements to the indicator panel (to the right of the tracks on the sequencer page?)

At the moment:
If a modular track is set to midi you only get a single red dot showing when notes play (it doesn't seem to flash when notes change like a normal trigger does either). 
If a modular track is set an expander you get nothing at all.
If track 7 or 8 is set to midi you get nothing at all.

The modular tracks are great with all relevant information shown. It would be nice to have something to show what's going on with other types of track.

Obviously expanders have multiple/re-routable outputs so it's more challenging to decide what shoud be shown, but even showing some trigger dots would be better than nothing. I am sure you (Thomas) could come u with a great solution together with community input.

If the display could change with its type (so for instance if CV16 was assigned to track 2) then that tracks' indicator display could change to a little grid with 16 dots to show triggers (as an example) that would be awesome.
I don't know how "locked in" the indicator panel graphics are though, or whether there are reasons why this wouldn't be possible.

With so many events flying around inside Nerdseq, as much visible information as possible being shown makes a huge difference in tracking down what is happening where.

Hope something like this could be considered.

I think you already got the point. They are no triggers with Midi and it shows if a Midi note is on or if all are off. 
As for the CV16, there is nothing really to show here. The trigger 16 states of the gates/triggers are not known by the NerdSEQ itself. It sends only a command and there is no feedback. 

7+8 has been classically audio tracks and even if they are not assigned to audio tracks, you can still use their samples or oscillators etc. You might always want to see them if they are running or not....

If you got any good ideas with knowning that there is no feedback from expanders, which the knowledge on how much is visible on the right side (and how little pixels)...I am always open for that of course.