Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
one question about groove
#1
maybe again just some misunderstanding on my side. but, how exactly is the groove setting working? from my understanding i can offset the actual trigger of a step by changing the value of steps groove. however, it seems that if i do so, not only that step, but the whole pattern is affected by that.

how is it used properly? i seem to not understand it
Reply


Messages In This Thread
one question about groove - by ello - 12-13-2019, 10:36 PM
RE: one question about groove - by skybox - 12-14-2019, 12:27 AM
RE: one question about groove - by ello - 12-14-2019, 12:43 PM
RE: one question about groove - by XORadmin - 12-14-2019, 09:51 PM
RE: one question about groove - by ello - 12-14-2019, 09:55 PM
RE: one question about groove - by XORadmin - 12-14-2019, 09:57 PM
RE: one question about groove - by ello - 12-14-2019, 10:01 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)