The Offset switch is a hardware switch and it is not possible to 'detect' how the switch setting is in software. I also don't see the benefit as all values that you can fill in are always positive values. It's just not possible to have positive and negative values with the available amount of digits (which is in most cases 2 or 3)
Just some insider information: If i would start the project again i would have make it different. Instead of offset switches most probbably the possibility to control the full range of -5 to +10 volt.
But yes, we stick with the hardware since a few years....Thats something for NerdSEQ2 (if that ever comes)
Just some insider information: If i would start the project again i would have make it different. Instead of offset switches most probbably the possibility to control the full range of -5 to +10 volt.
But yes, we stick with the hardware since a few years....Thats something for NerdSEQ2 (if that ever comes)
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!