(09-10-2021, 11:28 PM)Kid Yoshi Wrote: Hey there
I'm using the CV16 with an Assimil8or and I have a track from the CV16 set up to send an envelope with zero attack, full sustain and zero release - essentially a gate. This is used to trigger the Assimil8or and it works, however the volume on the Assimil8or is ~50% lower than if I trigger it with the Nerdseq dedicated Trigger output.
I'm pretty sure the Assimi8or does not use gate for volume level and interestingly, if I set either Attack to 01 or Release to 01 then the volume jumps up to it's correct level.
It's not a deal breaker but I do find it strange. I don't have a scope to visually see what might be going on.
THX
Have you played with the -5V/+5V or 0V/+10V switch of the CV16 channel that you use as envelope? My guess is it should be in the 0V/+10V position (i.e. flipped right)
HTH,
Michael