Release Candidate Firmware V3.01 RC4

[ianski]

Finally got round to updating and testing, very glad to find out that transposing midi tracks now seems to work perfectly! Thanks for keeping on top of issues... I can now use transpose again

I should have really said midi scales now work perfectly, as that was the bug I reported a while back, but was kind of connected to transpose too. I've tried all kinds of scales in both master and track settings and all works great. Really powerful stuff! I'm interested to check out the midi input harmonics and sample stuff too.

[Barney Rubble]

Dualchord - patch screen - note value starts at C# and status line displays C0

cheers
b

[djericray]

Just attempted to update to 3.1, my nerseq will not take the update. After update success screen unit reboots to a blank screen and stays there even after power cycling. Updated back to 3.0 and works fine. Any ideas on how to get 3.1 to work?

Which file did you use and are you sure the filecopy went 100% well? I didn’t hear any issues so far from other users.

I used the file within the candidate firmware v3.01 at top of this page. It gets to 49% and says updating succeed, it does this with all other firmwares as well except this one will not work

[666pastel]

Just attempted to update to 3.1, my nerseq will not take the update. After update success screen unit reboots to a blank screen and stays there even after power cycling. Updated back to 3.0 and works fine. Any ideas on how to get 3.1 to work?

Which file did you use and are you sure the filecopy went 100% well? I didn’t hear any issues so far from other users.

I used the file within the candidate firmware v3.01 at top of this page. It gets to 49% and says updating succeed, it does this with all other firmwares as well except this one will not work

I am also having this issue. im on an early version nerdseq, number 14 and I will not get past the 49% screen and it just keeps going to black after saying success screen.

[XORadmin]

Just attempted to update to 3.1, my nerseq will not take the update. After update success screen unit reboots to a blank screen and stays there even after power cycling. Updated back to 3.0 and works fine. Any ideas on how to get 3.1 to work?

Which file did you use and are you sure the filecopy went 100% well? I didn’t hear any issues so far from other users.

I used the file within the candidate firmware v3.01 at top of this page. It gets to 49% and says updating succeed, it does this with all other firmwares as well except this one will not work

I am also having this issue. im on an early version nerdseq, number 14 and I will not get past the 49% screen and it just keeps going to black after saying success screen.

In general the firmwares should work with all NerdSEQ generations. The first ones got a visual issue while flashing and indeed overflow at half of the flashing and show in the end a percentage < 50% but 'succeed'. This is (normally) fine then.

However, I will have a new version anyways soon and before I release it I will test it (as usual) with multiple NerdSEQ versions (small screen, big screen, old bootloader...).

[Static_channel]

- added resampling screens for the samples so if a sample is too long (or manually by loading the sample with SHIFT+OK) a lower samplerate can be selected
- loading samples in a lower samplerate (allows a longer sampletime) can be selected with or without interpolation
- added 24 and 32bit PCM and float sample support, fixed some sample loading issues

works perfectly
Thanks