09-28-2020, 08:55 AM
(09-28-2020, 03:54 AM)broecker Wrote: Hello,
When using the Glide attribute on the More CV 16 NSA set to GLC:01 I noticed that my CV signal that was going from -5v (000) to +5v (FFA) now only glides between -5v and 0v. Should it not just smooth out the CV and not limit it to a 5v window? Please let me know.
Thank you,
Hey,
i just tested it and it glides normally from -5 to +5 Volt here. There is no limit or window.
Is it possible that you already set it to the other value again before it reached the +5 Volt?
GLC01 is a really slow glide and it takes ca 3.5 seconds until it reached from -5 volt to +5 volt.
If you add like some glide-steps (eg GLS03) then it directly goes much faster with GLC01.
Maybe that is your issue?
Else, please provide me your projectfile so i can check if i can reproduce your issue.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!