NerdSeq is amazing. It is my master controller, and I use it in basically all my patches. Thanks a lot for all your work and support for this amazing sequencer. 

This is a long shot (there is most likely a hardware problem) but since NerdSeq is becoming a master controller, I was wondering if it can act as a master on the select-bus. It would be great, if it could send its clock, "program change", and other select-bus messages to the modules that are compatible with this standard (e.g., Mungo, Malekko, Disting, etc.).

This might be a bit of a stretch but I found myself wondering if the CV inputs could be hijacked to respond to triggers to input samples in the way they can be for CV. I.e. tap some trigger patterns in to CV input 1 with like a Shakmat Four Rooks or then something similar, it records directly in to ch 7. I guess the sample selection might be an issue here but even if it's the last sample used, getting the beat in there via tap and then changing the sample after should incredible. And then feeding gate patterns in to the nerd and recording snips and then overdubbing - SO MUCH POTENTIAL FUN. 

Sorry if it's come up before!

Hi,

Sorry I'm asking so many questions recently but I have another clocking question.

The main clock output (when set to DINSYNC) is very consistent when sent to other modules, eg. they read the exact tempo.
However, when sending out a 24ppqn clock from a pattern (programmed 16th notes and then the track set to *6 speed) the tempo on the external modules moves between 160 and 162. is there a reason for this?

Also the patterns trigger output is slightly behind that of the main clock output. This is a problem for some of my modules which require a 24ppqn clock and a reset as if im clocking them from the main output, the reset for a track trigger output is slightly behind.

Thanks again!

Is it possible to have a track assign default setup? For example i want to have track 6 default to the trigger expander, rather than standard cv/gate.

Maybe this is too much of a specific case use but I currently use a midi track to sequence an external drum machine and I was wondering how possible it would be to add Groove settings for each of the 4 voices.  I really love building fills where the snares have a heavy swing but everything else stays straight and there currently isn't a way to make that possible as far as I can tell.  Maybe adding a Groove value in the velocity column with Shift + OK that overrides the main groove at the far right?

Thanks as always!!

Hi All, 

When you add FX to the tracks in what order is it applied, Fx1, then FX2, then 3 then 4, I assume?

Also how is it ranked in terms of the rows information, is the entire row consider before the step is played?

Cheers

R.

Hi,

Do you know what the latency is from triggering from the midi expander?

I'm sending triggers out from the Nerdseq and also from the midi expander to the same drum module. 

I've got them pretty bang on by delaying all non-midi tracks by OC in the track delay. However, the sample tracks dont have a track delay setting...

Midi jitter is annoying though!

Hi,

How do you control all 16 outputs from this expander?

Hi,

New user here, got it today and absolutely loving it!

I wonder if it would be possible to have a mode for when input recording is enabled (cv note + gate/cv note + trig), where the cv is passed when not recording so you can preview before recording?

Cheers

R.

There are a lot of times in both Sequencer and Pattern screens where I want to copy a bulk section of multiple tracks onto another section further down to piece them together very quiclkly, or add notes or rhythms from one Pattern block down to the next page, but the [--] value is carried as well, overwriting any information already on that step.  I would love a way maybe in song setup to enable or disable a way for Copy/Paste to ignore blank values when moving data!